Services
Project Planning and Logistic
Automation
Custom Mounting.
Brackets and Spools.
Controls Installation.
Package Assy.
Calibration.
Modifications
Stem Extensions.
End Preparation.
Packing & Gasket Change.
Testing
Hydrostatic Pressure.
System Leak Detection.
Function & Cycle Testing.
Control System.
Radiographic Examination.
Finite Analysis.
Valve Modifications
Seats And Seals
New seats and seals can be produced in-house to save on factor lead time for crucial delivery requirements.
Stem Extension
We can supply stem extensions to facilitate the manual operation of valve that will be buried or heavily insulated.
Packing And Gasket Installation
OCV can prepare your valves with the particular packing and gasket that will offer the best sealing characteristics your service conditions require.
By-Passes And Valve Body Drains:
We have in-house capabilities to supply your by-pass requirements as well as any plug or clean-out port bore and threading that may be needed.
Special Coating Service
We can supply the required external and internal coating the service conditions call for. Valve and actuator packages can be coated together after assembly to keep it protected as a single unit from the particular corrosive atmosphere your service may have.
End Connection Preparation
We can modify the existing end connection arrangement of most valves and supply various combinations of end connections to facilitate the installation process in non-standard or custom piping configurations.
Valve and Actuator Testing
Control Valve Function Testing
All valve automation packages are function-tested prior to shipping from our facility. Checkpoints are included in the process to determine correct assembly of all components and to make sure the actuator and controls have been properly installed with all needed adjustments.
Radiographic analysis and other non-destructive tests can be performed at our facility as a service for your testing and safety requirements.
Hydro-Static Testing
Full in-house pressure testing capabilities can be performed on any of our valves or your supplied valves. Valve automation assemblies can also be pressure tested after the actuator has been fit in order to confirm the actuator sizing and function. We can also test your on/off or shutdown valve in a cycle test at that time to prove its ability under full differential pressure.
Let’s Build Your Project!
We offer best industrial services.
30+ years of experience